Help with using Ninja AUD MCQ’s.

  • Creator
    Topic
  • #191346
    rp 12
    Participant

    NINJA Question –

    Hello one and every fellow Ninja’s in this forum,

    I have started using Ninja MCQ’s and Sims and would want to try go over all the questions once. Just to see how am I doing with other than Becker MCQ’s, and Sims.

    Step 1: I did go to Custom+Sims and selected the categories I wish to study:

    Step 2: So, I selected chapters 1, 3, and 5 respectively.

    Step 3: Questions selected from “All Questions”. Is it all the MCQ’s from 1,3, and 5… This has about 758 MCQ’s? I asked this because when I go to session duration, I don’t know which one to select. Should I select 60 minutes? Since this is the maximum minutes. Or should I select ‘New Questions’ in every session I take. For example, today I select same chapters mentioned above – I select ‘New Questions’, and work out 75 MCQ’s. Will this be ‘untested questions’? every time I sit for new session tomorrow or after few hours? Or I can face same questions again and again?

    Listed above are the steps on how I am selecting MCQ’s for selected chapters only. But I cannot make selections for all the MCQ’s from those selected chapters. Would it be possible to see how I can select all the MCQ’s for example from chapter 1, 3, and 5. Sorry for the long post, but any help with this or how you as a users get done with all the MCQ’s?

    "Success in life comes when you simply refuse to give up, with goals so strong that obstacles, failure, and loss act only as motivation"

    AUD: 68, 62, 77✔ (expires 10/31/16)
    FAR: 53, 48, XX (retake 6/16)
    REG:
    BEC: 53

Viewing 2 replies - 1 through 2 (of 2 total)
  • Author
    Replies
  • #638067
    ruggercpa2b
    Participant

    I do the question in sets. So instead of picking 60 minutes for session duration pick the number of questions you want to complete in that sitting. I usually do sets of 30 if I am home and when I am studying at work during my lunch hour I do either sets of 5 or 10.

    As I go through I do the custom search and pick new questions in order to go through all the questions at least once. Then I pick the trouble areas and then eventually I just let the software pick for me as I get closer to my exam date.

    If you do a search in the forum I think people have posted how they study using the Ninja MCQs. As you can see from my scores below the Ninja MCQs helped go from a 47 to 66 to 73. When I got the 47 I was not using Ninja and when I got the 66 I did not listen to Jeff when he told me to get my scores trending in the 80s. That 73 is just from evil simulations.

    AUD - 73, 72 retake 7/2/2016
    BEC - 8/20/2016
    REG - TBD
    FAR - TBD

    I am so ready for this nightmare to be over. Been at this way too long.

    #638068
    rp 12
    Participant

    Thanks ruggerCPA2b for the respond to my post. Sorry to hear about the AUD part miss by 2 points… But definitely glad to hear that you have progressed well with Ninja MCQ's, and Sims package. My story with AUD is also similar to yours. In my very first two attempts – I failed badly (34, and 45 – I didn't study all 6 chapters of Becker), in my third attempt I got 68 (used Becker and went over all 6 chapters) – def weak in Sims. So hope my fourth attempt, and 2nd attempt with all chapters prep gives the magic # of 75.

    My exam is on 2/6. How is your prep coming along?

    "Success in life comes when you simply refuse to give up, with goals so strong that obstacles, failure, and loss act only as motivation"

    AUD: 68, 62, 77✔ (expires 10/31/16)
    FAR: 53, 48, XX (retake 6/16)
    REG:
    BEC: 53

Viewing 2 replies - 1 through 2 (of 2 total)
  • The topic ‘Help with using Ninja AUD MCQ’s.’ is closed to new replies.